Known Issue ID: 16951
When you plug a RED W.M.D. into the 1.5A or 3.0A on the DSMC2 Production Module or RED RANGER camera system, you will receive an overcurrent error.
Found in Firmware Version:
Target Firmware Fix:
RED W.M.D. is not supported using the 1.5A Aux power on RED RANGER. When the Power Out Fault error message is received on 3.0A AUX PWR port, hit Reset (with the unit still connected) to clear the issue. If Leave Off is selected, the AUX PWR Rear will need to be Reset under Menu > Power > Power Out. Contact RED Support if issue persists.