Overcurrent When Using RED W.M.D.

Known Issue ID: 16951

Issue Summary:

When you plug a RED W.M.D. into the 1.5A or 3.0A on the DSMC2 Production Module or RED RANGER camera system, you will receive an overcurrent error.


Found in Firmware Version:

7.2.1


Target Firmware Fix:

Investigating


Workaround:

RED W.M.D. is not supported using the 1.5A Aux power on RED RANGER. When the Power Out Fault error message is received on 3.0A AUX PWR port, hit Reset (with the unit still connected) to clear the issue. If Leave Off is selected, the AUX PWR Rear will need to be Reset under Menu > Power > Power Out. Contact RED Support if issue persists.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

244 comments

Article is closed for comments.