Overcurrent When Using ARRI UMC-4 Follow

Known Issue ID: 16288

Issue Summary:

When you plug an ARRI UMC-4 into the 24V RS or P-Tap ports on the DSMC2 Production Module, you will receive an overcurrent error.


Found in Firmware Version:

7.2.0


Target Firmware Fix:

Investigating


Workaround:

Boot the ARRI UMC-4 via P-Tap on battery, and then connect the 3-pin Fischer cable to the 24V RS port, and then disconnect from battery. When available, contact RED Support to send your camera in for service.

Have more questions? Submit a request

1 Comments

  • 0
    Avatar
    RED Web & Marketing Support
    A workaround for Overcurrent When Using ARRI UMC-4 - 16288 has been added.
Article is closed for comments.