LCD Does Not Turn On After Being Disconnected

Known Issue ID: 14210

Issue Summary:

This issue occurs only with the following configuration: 1) DSMC2 camera on firmware 7.0.1; 2) camera is turned on; 3) an LCD is attached to the Secondary EVF/LCD port; 4) either a battery module or the DSMC2 Jetpack-SDI Expander is attached. If you are using the configuration described above and disconnect the LCD from the Secondary EVF/LCD port, the LCD will not turn on when you reconnect it to the camera.


Found in Firmware Version:

7.0.1


Fixed in Firmware Version:

7.0.2

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

1 comment

Article is closed for comments.