Topics covered on this page:
- General: Module or Lens Mount Not Functioning
- Camera Does Not Recognize Lens
- Camera Displays N/A for Aperture
General: Module or Lens Mount Not Functioning
Symptom
Module or lens mount is not functioning correctly, or is not communicating with the camera.
Potential Resolutions
- Perform a Hardware Rediscover.
- Upgrade your camera firmware.
- Perform a System Restore.
For more information, download the corresponding operation guide for your camera.
Camera Does Not Recognize Lens
Symptom
The camera does not recognize the attached lens.
Potential Resolutions
- Ensure that the lens is compatible.
- If using a PL lens, ensure that the camera is providing power to the lens: go to Menu > Settings > Setup > Lens and select the Enable Power to Lens check box.
- Detect the lens: go to Menu > Settings > Setup > Lens and select Detect Lens.
- Perform a Hardware Rediscover.
For more information, download the corresponding operation guide for your camera.
Camera Displays N/A for Aperture
Symptom
The camera displays N/A for aperture when a lens is attached.
Potential Resolutions
- Ensure that your lens is completely locked in place.
- Remove your lens mount. Check the connection points for damage or debris. Install your lens mount.
- Install your lens slowly, taking care to ensure the lens fully locks into place.
- Perform a Hardware Rediscover.
- Re-install your camera firmware.
- If your camera is on beta firmware, downgrade to the release build.
- If you are using a DSMC® PL mount, go to Settings > Setup > Lens and ensure that power is enabled.
NOTE: Some lenses do not display the aperture information because they are incompatible. Some PL lenses do not have i-technology data.
For more information, download the corresponding operation guide for your camera.
Comments
Article is closed for comments.